Crispin Posted September 21, 2015 Report Share Posted September 21, 2015 I've setup wheel speed sensors but I cannot get them to work with my link g4 plus extreme.The are a bit special being wire only.I've tried everything I can think of without success.These sensorshttp://www.ifm.com/products/gb/ds/IE5238.htm Quote Link to comment Share on other sites More sharing options...
Simon Posted September 22, 2015 Report Share Posted September 22, 2015 I think you might need to wire one side to a voltage supply 5 or 12V and the other to the Di.It will then pulse 5 or 12V to the Di dependent on the tooth position relative to the sensor. Quote Link to comment Share on other sites More sharing options...
augusto Posted September 22, 2015 Report Share Posted September 22, 2015 Hello CrispinPlace a 4k7 resistor in series with the sensor.Remove the signal to the digital input of the amendment of the resistor with the sensor to the negative (ground).Must be supplied with 12 volts.Augusto. Quote Link to comment Share on other sites More sharing options...
Crispin Posted September 24, 2015 Author Report Share Posted September 24, 2015 I solved it earlier this week with this setup:330 ohm resistor -> white cabel of sensorblack cable of sensor -> DI input of Link AND 500 ohm resistor to ground. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.