Jump to content
Crispin

2 wire wheel speed hall sensors

Recommended Posts

I think you might need to wire one side to a voltage supply 5 or 12V and the other to the Di.

It will then pulse 5 or 12V to the Di dependent on the tooth position relative to the sensor.

 

Share this post


Link to post
Share on other sites

Hello Crispin

Place a 4k7 resistor in series with the sensor.
Remove the signal to the digital input of the amendment of the resistor with the sensor to the negative (ground).
Must be supplied with 12 volts.

Augusto.

Share this post


Link to post
Share on other sites

I solved it earlier this week with this setup:

330 ohm resistor -> white cabel of sensor

black cable of sensor -> DI input of Link AND 500 ohm resistor to ground.

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...