Jump to content
Sign in to follow this  
Philip Griffiths

IAC Valve

Recommended Posts

Hi, might be a bit of a dumb question... my current IAC valve is causing numerous issues (sticking - are know to fail) and I have a bosch (0280140551/AC309) to install instead.  This is a 2 Terminal version.  Appears these are a rotary valve type that utilises set voltages through an armature for % opening, and must have a spring return (more info here: http://mbworld.org/forums/e-class-w124/503103-idle-air-control-valve-airflow-versus-control-voltage.html).  

Would wiring be the same as if this were a two terminal solenoid valve/a four terminal ISC stepper motor and only use two aux's?

Thanks,
Philip

Share this post


Link to post
Share on other sites

Looking at the image that looks very much like a conventional bosch 2 wire solenoid.

The unique bit of this solenoid is that at 30% duty cycle the solenoid will be closed and will open at figures above and below this.

If you run a ISC minimum clamp at 30% it will be fine to use.

I would wire as per a standard 2 wire solenoid. 12V to one pin and the other back to Aux 1 or 2 on the ECU. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...