Jump to content
gijsje

User CAN Setup

Recommended Posts

How can i change the User CAN Setup ?

All is gray and i can not change it :(

I did try the vipec software and there you are able to change and to save but when you open it in the link software it says that it was not made with the link software

Share this post


Link to post
Share on other sites

The user configurable CAN setup was a VI-PEC only feature. However, on the last version of VTS (V 4.10.2) it may be possible to open your Link ECU (or offline base-map) in VTS. This may allow you to setup the User configurable CAN. 

Share this post


Link to post
Share on other sites

i have now installed the VTS (V 4.10.2) and did try to make a new lcc file and edit an existing lcc file but with both i do get the same message that it was not made with the link software and then it does not load :(

Is there a way to enable this option in the link G4 software?

Share this post


Link to post
Share on other sites

It looks like this is not going to work for you. Development on the G4/VX range of the ECUs stopped some time ago, so this is unlikely to change.

What device are you trying to communicate with?

Share this post


Link to post
Share on other sites

Although you can not do a user CAN setup, from memory I believe you can load the 'Generic Dash' file. This is more limited, but still has most important parameters. 

Another option would be to use the Serial output.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...