nzjailbar 0 Report post Posted February 1, 2016 Hi wired up and finally ready to start 1uz .Running windows 7 on computor and no online help on pc link.Does anyone have instructions on how to calibrate triggers . Cheers Neil Share this post Link to post Share on other sites
Scott 151 Report post Posted February 2, 2016 Hi,Is your 1UZ the VVT engine, or the twin distributor engine? Share this post Link to post Share on other sites
nzjailbar 0 Report post Posted February 2, 2016 non vvti .running waste spark and 36-2 trigger Share this post Link to post Share on other sites
Scott 151 Report post Posted February 2, 2016 This should help. Make sure you press enter after entering a new value in the base timing window. Calibrate triggers.pdf Share this post Link to post Share on other sites
nzjailbar 0 Report post Posted February 17, 2016 Hi , tried that and get a different screen to shown . Was getting no spark on crank and than 3 sparks after i stopped cranking . changed to another coil setup and now no triggers at all. Share this post Link to post Share on other sites
Scott 151 Report post Posted February 17, 2016 Can you do a screenshot and show us what your screen looks like? Are you using the Multitooth/Missing trigger mode? Share this post Link to post Share on other sites
Simon 140 Report post Posted February 17, 2016 Assuming you don't have a trigger 2 and are doing all the timing from the crank sensor only make sure you have the trigger 2 sync mode set to none.Also polarity of the crank sensor is going to be critical. Share this post Link to post Share on other sites
nzjailbar 0 Report post Posted March 8, 2016 sorry haven't been on for a while to reply , work went nuts .The trigger calibration is different to link as g3 not g4 .Any way put lexus 12 tooth trigger back in and set to 1uz triggers and got it to fire .New problem is that I have to go to multi tooth and then to 1uz triggers to get to fire . Turn key off and then have to go back and reset . Cheers neil Share this post Link to post Share on other sites
Scott 151 Report post Posted March 9, 2016 Hi,It could be something like ECU hold power or Anti-theft. Do you have either of these setup? If yes, are you sure they are setup correctly? Share this post Link to post Share on other sites
nzjailbar 0 Report post Posted March 10, 2016 Don't think I have any of thouse . Will try and have a play this weekend Share this post Link to post Share on other sites
Scott 151 Report post Posted March 14, 2016 Feel free to post your base-map and a PCLog of you trying to start if you like. Here is a video on how to do this: Share this post Link to post Share on other sites