Jump to content
Mxredbaron

Using high Independence injectors with VLLink

Recommended Posts

I have Bosch ev14 high Independence 1000cc injectors currently installed on my RB30 SOHC.
I brought them before i got the VLLink plug & play ecu and I've now noticed that the ecu only works with low Independence injectors. :huh:

Can i run the High Independence injectors without issues, Or is it better to sell off my brand new high Independence set & perches Low Independence injectors 
Any information is regarded as helpful.

Edited by Mxredbaron

Share this post


Link to post
Share on other sites

I think I spoke to you earlier on the phone about this. For anybody else who might read this in the future, yes you can run high impedance injectors directly from the injector pins of the VLLink ECU.

Share this post


Link to post
Share on other sites

thanks scott

As mentioned in previouly I have high impedance injectors. 

Is this the cord I'll need to use to run them? 

Also I have a innovate ecf-1 with wideband ,flex fuel & fuel prespressure  sensor what loom will I need to integrate all of that into my ECU?

Tom

Share this post


Link to post
Share on other sites

No you do not need the XS loom to run high impedance injectors. These will be wired in to the existing injector wiring (replacing the stock injectors)

The XS loom for this is needed if you wish to run 6 coils rather than the stock single coil.

There is also a second connector the same that offers inputs that would be used for connecting the wideband, fuel pressure sensor and the Flexfuel. So for this an XS loom would be needed.

 

 

 

Share this post


Link to post
Share on other sites

I'm not understanding the term "wired in" to me that  implies getting out tools and running lengths of cable ,soldering connections ect. As that's what I've been assuming needs to be done since told the ecu only works with low impedance injectors. again implying I had to use an alternate method to drive them. 

In fact I haven't even had my engine run more then a minute because of it. Now I'm lead to believe that its infact not the case. Simply confused and thankful that you have patience for situations such as this. 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...