Ducie54 46 Report post Posted April 1, 2016 Is it possible have the option to label the CAN frame parameter. So when you setup up a gauge or look at run time values there is more info then say CAN ANV1 Quote Share this post Link to post Share on other sites
Scott 151 Report post Posted April 4, 2016 Hi Nigel,We'll pass the suggestion on to the engineering team. One option in the mean time would be to use the CAN Thermocouple channels, as this will give you a bit more of a clue when looking at them in logging, etc. Quote Share this post Link to post Share on other sites
Ducie54 46 Report post Posted April 5, 2016 Thank-you Scott. Quote Share this post Link to post Share on other sites
Grant Baker 16 Report post Posted May 22, 2018 Did this ever go any further? I'm receiving a lot of data via CAN into a Fury (from a MoTeC dash and PDM) and it takes ages to remind myself which CAN DI does what. It would be great to have labels attached to the CAN DI and CAN ANA inputs... Quote Share this post Link to post Share on other sites