Auxilary problems

[Jon.C]

i have an built in G4 storm in my EVO 6. 

I dont Get any signal out from any of the aux outputs, it only works when i choose to use the test function. Then i got both high and low signals. 

I want to controll fuel pump. 

When its all hooked with relay controlled by low side of ecu  it wont prime ore anything, also tested while cranking

Can anybody give some tips? 

[Steve]

Post your pcl and let us have a look

[Jon.C]

Post pcl? How? 

Post your pcl and let us have a look

Post pcl? How?

[Steve]

Unnless its fixed this forum wont let us post a pcl file extension. But you can attach it as a zip file. Or use a file host service.

[Jon.C]

Unnless its fixed this forum wont let us post a pcl file extension. But you can attach it as a zip file. Or use a file host service.

see attachment for pcl file, hope you have time to take a look at it as soon as possible, because i have dyno run cooming up soon. Thanks in advance

Edited April 15, 2016 by Jon.C
Removed pcl file

[Steve]

I pressume you are trying to use AUX 1 as fuelpump? The one set to "test" in the PCL?

I see that you ALSO have ignition drive 3 set up for fuel pump. You can only have one output designated to this so you need to switch that one off..

 

[Jon.C]

Correct about aux 1 for fuel pump. I Know i can only use one, but this pcl file you got was only a test with allot of different stuff. 

 

Im sure what you mentioned now is not the problem. 

[Steve]

Have you tried to hook it up to a different output? like aux 8 or something.
Could be some bug sor something.

 

Also, are you getting RPM reading and "yes" on both triggers when cranking?

Edited April 14, 2016 by Steve

[Jon.C]

I tryed different outputs, same issue. 

I have not checked both signals while cranking, but if any help the car starts fine with fuel pump direct on 30 power. 

[Simon]

You need to make sure that the is only one output assigned as fuel pump.

If two are assigned the same function one will not work.

To help we need to see the file exactly as you are trying to use it.

[Jon.C]

You need to make sure that the is only one output assigned as fuel pump.

If two are assigned the same function one will not work.

To help we need to see the file exactly as you are trying to use it.

OK, i tryed disabled all outputs and assigned one output to fuel pump. I have also tried different pins, aux 5-6-8-1 has Been tested. All of them act in the same way. 

[Scott]

Please see the following video to see how to record PCLog and how to save your base-map:

Then either upload the files on the forum or email them to [email protected]. If emailing them please include a link to this forum thread so we know what the files are for.

[Jon.C]

Hi, i found some earth cables that is not to good, i fixed this and the problems is now ok!  Now im happy!!

Thanks for all of the help!