Jump to content

Knock senor wiring


Nburns

Recommended Posts

Hi,

If you are using the factory knock sensor, and it only has one pin, wire this to the pin 'Knock 1' on the B connector of the Fury. 

If you are fitting a knock sensor to the engine then I would recommend fitting a 2 pin wideband type knock sensor. This is because most OEM knock sensors only output a narrowband frequency and the band needs to match the resonant knock frequency of the particular engine.

Scott

Fury B.PNG

Link to comment
Share on other sites

JZ motors have two knock sensors, one at each end of the block?

Are you sure that you dont have two seperate shielded wires, one for each single wire knock sensor on the engine. 

If so, wire up one each to knock 1 and knock 2.

Edited by Davidv
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...