Zeus Posted July 27, 2016 Report Share Posted July 27, 2016 HiLaunch control does not disengage after exceeding the disarming speed, please advise.Subaru STI V7 using Link G4+ pluginThanks in advance Quote Link to comment Share on other sites More sharing options...
mapper Posted July 27, 2016 Report Share Posted July 27, 2016 Check under the chassi setup if non-driven wheelspeed is setted up. You can confirm correct reading under F12 tab or in a datalog. Rich RDE and Zeus 2 Quote Link to comment Share on other sites More sharing options...
Rich RDE Posted July 27, 2016 Report Share Posted July 27, 2016 I would assume it does not see wheel speed like mapper has mentioned. You could also be hitting a limiter somewhere else. Check to make sure that this is not interrupting the launch control. I.E. you think it's launch control when really it is a completely different limit activating. Most likely wheel speed but can never be too sure. Zeus 1 Quote Link to comment Share on other sites More sharing options...
Zeus Posted July 28, 2016 Author Report Share Posted July 28, 2016 Check under the chassi setup if non-driven wheelspeed is setted up. You can confirm correct reading under F12 tab or in a datalog. You are spot on, it hasn't been setup.Apologies for the newbie question, what would the "non driven wheel speed source" be on an all wheel drive car? Quote Link to comment Share on other sites More sharing options...
Scott Posted July 28, 2016 Report Share Posted July 28, 2016 It's a good question, there is no non-driven speed source on an all wheel drive car. You can set the non-driven speed source to be the same as the driven speed source, however there will never be any slip, and if using it for launch control the launch control will disable if your driven speed source is faster than the threshold you have set.Alternatives could include taking non-driven wheel speed source from a ground speed sensor, or a high speed GPS. Or you could use a timer or some other condition (gear?) to disable launch control.Scott. Zeus 1 Quote Link to comment Share on other sites More sharing options...
Zeus Posted July 28, 2016 Author Report Share Posted July 28, 2016 Thanks a stack, I appreciate the assistance Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.