balldlox Posted September 14, 2016 Report Share Posted September 14, 2016 Hello,I have transplanted a 13B into my 72 super beetle.The FFE trigger only has 3 wires and the general G4 instructions call for 4 wires. What is the correct way to connect them?Any help is greatly appreciated.G4RX, AEM smart coils, FFE hall effect....... Quote Link to comment Share on other sites More sharing options...
Scott Posted September 14, 2016 Report Share Posted September 14, 2016 Cool project, I'm envisioning a good power to weight ratio. I have a beetle, but stayed with a 1776cc type 1 engine.Looking at the FFE website I think this will be the wiring for your sensor:The wire colours look the same.Scott. Quote Link to comment Share on other sites More sharing options...
Simon Posted September 14, 2016 Report Share Posted September 14, 2016 (edited) Trigger settings in the ECU will need to be Multi Tooth missing.Set trigger 2 sync mode to none.Wiring wise you will only be connecting to the trigger 1 input. Edited September 14, 2016 by Simon Quote Link to comment Share on other sites More sharing options...
balldlox Posted September 14, 2016 Author Report Share Posted September 14, 2016 Thanks for the quick reply this should keep me moving along.Simon - I have 0 experience with this, thanks again.Scott - Yes that is exactly what I have.And yes power to weight should be fun. I previously repowered this car with a 2.0 914 engine and it was a blast to drive.I appreciate the help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.