Jeronkie Posted September 27, 2016 Report Share Posted September 27, 2016 Hi Guys (and Girls)I am looking to buy TTLink - #TT+ but need some advice ,The car is Audi S3 (225) 2003 BAM essentially the same as the TT Quattro 225 , it is a project car with bigger turbo, 80mm throttle, 1000cc etc etc , If I use this will I retain all functions , ESP, ABS ,T/C , Haldex ,Dash, A/C (I don't have cruise control)I read that Link/ViPec ? have done a lot of work with CAN tie in but need to understand what it will not do and my limitationsYour feedback will be much appreciatedCheers Quote Link to comment Share on other sites More sharing options...
Scott Posted September 28, 2016 Report Share Posted September 28, 2016 Hi,We have not used the TT ECU on the BAM engine before, but the chart I have says this should work. Out of your list the following will not work:ESP and Traction Control.The G4+ ECU is able to be setup to do traction control though. it will use the four wheel speeds coming in over the CAN bus.In June one our TT ECUs was fitted to a 2007 Seat Ibiza, and this car had a problem with two lights staying on on the dash:These are the known requirements:Engine must be 1.8TECU header must have two connectors, 121 pins total.Must be Drive By WireMust be manual transmissionFWD or 4WD (Haldex) Scott Quote Link to comment Share on other sites More sharing options...
Jeronkie Posted September 28, 2016 Author Report Share Posted September 28, 2016 Hi Scott ,thank you for the reply , and the quick supportI followed the thread you mentioned unfortunately no final outcome - hope it worked out ,What I will do is get a unit and test it (worst case scenario the dash lights and ABS will not cooperate) If I have issues I will get a can sniffer and take it from there ,PS my car have all the mentioned requirementsCheers Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.