Jump to content
MRE32

car wont start

Recommended Posts

Well you got RPM. No trigger errors. The injector outputs are triggered. Fuelpump output turns on.

I would look for wet plugs, actual spark at the plugs, signal to the injectors (injectors are clicking or not when tested?), and fuelpressure (output is triggered but is the pump actualy running).

You have a testfunction for coils and injectors in the software.

You could also check timing with a timinglight but this should not be sceewed if it was ok before.

Share this post


Link to post
Share on other sites

I dont see much wrong in your log either.  ECU seems to be doing everything it should, most sensors are giving realistic numbers and the trigger seems happy. 

If you have a spark at the plugs then I would be starting to look at mechanical stuff now.  Maybe cam belt has skipped some teeth etc.  Start with a compression test.

A couple of things I noticed in your log that I will mention; battery voltage is low during cranking and cranking RPM is low.  ~9.8V & ~145RPM. Normally that wouldnt be a problem but sometimes with fouled plugs etc you need better than that, maybe battery is getting low?  The TPS stays at zero throughout your log - that might be just because you never touched the throttle or perhaps it isnt working.  It wont hurt to double check this is working since your main fuel table is TP based.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...