Rpm Limit Cut - R33 GTR Link

[BCNR33Zed]

hi guys, can someone help me with the RPM limit configuration?
I was liking my old rev limiter on my old Apexi Power FC ECU (bang, pops and flames).
This rev limit configurated in my Link G4+ now is really soft.. I'll want something more aggresive with some bangs etc.
I'm using this:

RPM Limit set at 8300 RPM

Ign%Cut mode,

Advanced mode ON,

Hard limit OFF,

Cut effect Adaptive,

Limit Ctrl Range 200rpm,

Hard Limit Activation 0rpm

End cut 50%,

Start Cut (TP100) 60%,

Start cut (TP Low) 30%,

TP Low 15%TP,

Exit decay 1% 20ms,

Limit Ignition Trim -7°

 

If someone can Help me I'll post the pcl file. I'm trying to configure also the Launch control for build some boost and do some bangs

[BCNR33Zed]

bump, can someone help me?

[Adamw]

Your End cut needs to be a bigger number than the start cut.  Try 100% end cut.  Try start cut (TP low) about 50 and start cut (TP 100) about 60.  Also try a smaller control range.

You will possibly need to use a 4d fuel table to add more fuel also. 

[BCNR33Zed]

Your End cut needs to be a bigger number than the start cut.  Try 100% end cut.  Try start cut (TP low) about 50 and start cut (TP 100) about 60.  Also try a smaller control range.

You will possibly need to use a 4d fuel table to add more fuel also. 

Is needed to activate the Hard Cut function?

[Adamw]

Is needed to activate the Hard Cut function?

The smaller the control range number that you use the more your effect becomes like a "hard cut".  No one can tell you what you need to make it "sound like a PFC" - you will need to experiment with these settings yourself until you find something that works.

[BCNR33Zed]

Okay, I will try.

thanks for the help