First Rev Up

[Andy Drummond]

Hi Everyone,

Question to all other Link users.

Trying to determine if it is my setup or not?

On the first throttle (rev up) after starting (power on), the engine hesitates (misses a beat) then rev's.

Any following throttle / rev ups, is excellent response.

 

Please reply with either yes / no on your engine or comments.

 

Cheers

Andy

[Adamw]

This could be caused by many things, however most likely just a tune/settings issue.  My pick would be crank enrichment or post start enrichment timeouts being too long.  

Log and map needed to be any more help. 

[Andy Drummond]

Hi Link Team

This issue is NOT about startup parameters.

 

I have done 2 logs.

The first log showing PercentageICut goes active on the first application of TPS. All future applications of TPS all OK.

Then in the second log applied TPS before cranking (power on and before starting engine). Then started engine and running for sometime applied TPS and NO PercentageICut.

 

This shows in the RPM Limit code there is a "one shot" (latched) condition in the wrong place.

 

Again I hope you will investigate.

Cheers

Andy

Log 2017-09-27 5;45;00 pm.llg

Log 2017-09-27 5;45;47 pm.llg

[Adamw]

Please attach your map also.

Edit, added later:  Actually I just took a look at your log, you have a gear shift cut being applied.  Turn that off if you dont need it, or if it is intended you will need to adjust the lockout conditions so that it doesnt activate during normal running.

Edited September 27, 2017 by Adamw

[Andy Drummond]

Hi Adam

Thanks for spotting that the Gear Shift was on.

Have turned it off as was not using it. Now all good. Thanks again.

 

Cheers

Andy