Toliski Posted December 7, 2017 Report Share Posted December 7, 2017 Hello guys I have a problem. My 3s gte with cop (same setup for a month ago running fine) Today as I drive the engine shut down and don't start again. I make a trigger scope. I check for ignition spark and the COP's don't fire. Whats the problem here? Trigger Scope Dont start.llg toliski map.pclr Quote Link to comment Share on other sites More sharing options...
Toliski Posted December 7, 2017 Author Report Share Posted December 7, 2017 And here is the log guys Log Dont start.llg Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted December 7, 2017 Report Share Posted December 7, 2017 You need to lower your cam sensor arming threshold down low. It doesn't rise past +0.48ish and your threshold is 0.5 at 0 rpm. Also there is a ton of noise on the cam sensor. Is this a harness that you made from scratch or is this a stock MR2 harness? If stock, I would suggest running the crank/cam wires externally to the harness with new quality shielded cable. Quote Link to comment Share on other sites More sharing options...
Toliski Posted December 7, 2017 Author Report Share Posted December 7, 2017 it's stock harness. but the engine run fine until now.... is there a possibility to burn all coils at the same time? And i try in downhill with gear and nothing. Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted December 7, 2017 Report Share Posted December 7, 2017 It is possible to burn all coils at the same time. Some other individual on this forum had that happen do to incorrect spark edge selected, but yours is correct. But now after looking further at your calibration, I do think your dwell might be a bit high for the coils. I would be running about 1ms less at operating voltage. Quote Link to comment Share on other sites More sharing options...
Toliski Posted December 7, 2017 Author Report Share Posted December 7, 2017 Sorry guys the ground wire for Cop setup just cutted. Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted December 7, 2017 Report Share Posted December 7, 2017 That will do it. Toliski 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.