Jump to content
bmt

BAP sensor readings

Recommended Posts

Hi there, question on my new Vipec - I have 2 setups for turbo polaris - and the new vipec I have set up shows the Bap sensor reading - which comparing to my other unit is incorrect- the MAP sensor is reading a bit high as well - the other setup I have is showing 93 .  Can you advise me of how to get the BAP sensor recalibrated - I'm assuming this is the internal VIPEC bap sensor.

 

 

image.thumb.png.e2ff4663b664fae791197f9fa8608995.png

image.png

Share this post


Link to post
Share on other sites

On the configuration  page, check the Baro sensor is still set to "marine".  If it is and it still reads incorrect then the sensor inside may have failed and you will need to contact tech support. 

Share this post


Link to post
Share on other sites

Thanks, Adam - its confirmed to be in Marine mode - I took my Vipec #1 and swapped between sleds - I get the same indications from swapping to a different sled - Ill contact tech support next week. Any body in specific to chat with? Thanks for the timely reply!

Happy Holidays,

 

image.thumb.png.a5dd279a93d7d6b79a3b8b1fcd44d6a5.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×