Gsab Posted January 11, 2018 Report Share Posted January 11, 2018 Please advise, I have configured An4 v as an input for my oil pressure. I am using a Gems 0 to 8 bar scale sensor with a 0 to 5v output. My issue is that I keep measuring 7.35 volts on An4 V which I think is telling me that I need to use a VDO Type resistor sensor. Not what I am after, Gems sensor is mounted and wired up except for the V88 input. How would I reconfigure this input for a 0 to 5 volt input please. Thanks. Quote Link to comment Share on other sites More sharing options...
ClintBHP Posted January 11, 2018 Report Share Posted January 11, 2018 It must be a calibration issue, the input can not read 7.35 volts. The AN Volt 4 input measures 0-5v When you set it to Oil Pressure what Cal table did you use ? Quote Link to comment Share on other sites More sharing options...
Gsab Posted January 12, 2018 Author Report Share Posted January 12, 2018 Hi Clint, thanks. Agree with you there,but Im measuring 7.35v on An4 v unterminated. I have used cal tables 1,2 and 3, poked around with others but keep getting this voltage measurement. Ive checked continuity from ecu plug as well and it is the correct wire. Quote Link to comment Share on other sites More sharing options...
ClintBHP Posted January 12, 2018 Report Share Posted January 12, 2018 10 hours ago, Gsab said: Hi Clint, thanks. Agree with you there,but Im measuring 7.35v on An4 v unterminated. Then that is what the error value is set at, the input will only measure 0-5v Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.