Jump to content
Demetris

Gear detection

Recommended Posts

Have some issues with gear display. I have setup my Gear detection all gears voltage as the volt i get on each gear from anvolt5 ( its where i connect the analog potensiometer of gearbox ) 

 

 My problem now is as the voltages are correct for each gear the ECU it does not display the correct gear. 

 image.png.b133b85f4e783eb96377cc4eda8080f0.png

 

image.thumb.png.1230322d3ae1167000d0c4fe93f064c0.png

 

 As you can see on the shots, i am on N and the voltages is correct ! but ECU things i am in 1 gear !  

Any hits ? dont know what else to check ! And its really irritating as i have to remember all the time what gear i am on : ( 

 

Share this post


Link to post
Share on other sites

This is odd, most of your settings visable look correct.  When I duplicate your settings on bench it works ok for me.

Are you on latest firmware 5.6.5.3389?  Can you attach your tune file or send to NAjJcZt.png

 

sFVOpnW.png

Share this post


Link to post
Share on other sites

Yes i have the latest firmware ! 

 Also e-mail to you the file i am testing on the car ! I know that looks stupid that why i ask for help ! bcs as i see also the settings everything looks correct ! 

Share this post


Link to post
Share on other sites

 

17 minutes ago, Demetris said:

Also e-mail to you the file i am testing on the car !

I have received your file and briefly tested it, it seems to work correctly for me.  My only thought now is perhaps there is a corrupt table or something in the background? 

Lets try a factory restore:

  1. ECU controls>restore to factory settings.  Choose yes for both messages that follow.
  2. Powercycle ECU (turn power off then back on).
  3. File>open, then load in your original map. 
  4. Test gear detection again.

 

Share this post


Link to post
Share on other sites
1 minute ago, Adamw said:

 

I have received your file and briefly tested it, it seems to work correctly for me.  My only thought now is perhaps there is a corrupt table or something in the background? 

Lets try a factory restore:

  1. ECU controls>restore to factory settings.  Choose yes for both messages that follow.
  2. Powercycle ECU (turn power off then back on).
  3. File>open, then load in your original map. 
  4. Test gear detection again.

 

OK ! i will give it a try tomorrow and come back ! hope will be the solution to my problem ! thanks ! 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...