StijnFSP Posted January 25, 2018 Report Share Posted January 25, 2018 Hi, i have a wrx link v3-4 and want to wire in a egt sensor i have one from link and a thermocouple but i was reading on the help and i didnt find the right way to wire it in ? i understand that i need an amplyfier can u tell me witch one i need? Quote Link to comment Share on other sites More sharing options...
Scott C Posted January 25, 2018 Report Share Posted January 25, 2018 Any k-type 0-5v amplifier would work. Not an endorsement, but just an example I found:http://www.exhaustgas.com/ProductDetail.asp?ProductID=1891&DepartmentID=&CategoryID=&RepID=&BasketID= The signal out from the amp needs to be wired to any available analog input. Choose "EGT 0-5v" for the function. Quote Link to comment Share on other sites More sharing options...
Obada Posted January 4, 2020 Report Share Posted January 4, 2020 Hi Excuse me How i can calbrate it on ECU? Quote Link to comment Share on other sites More sharing options...
Obada Posted January 4, 2020 Report Share Posted January 4, 2020 And how to install on link Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted January 4, 2020 Report Share Posted January 4, 2020 choose EGT (0-5V) for the input, then choose a calibration table, probably table 4,5 or 6 as most thermocouple amplifiers will have a linear output, then enter the calibration values in that table. HTH, Richard. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.