o_dd Posted February 20, 2018 Report Share Posted February 20, 2018 Hello. I am using AEM CD-7 for WRXLINK I want to display exhaust temperature, fuel temperature and analog voltage on the CD-7 but I can not do it now I confirmed, but because it is not in "Transmit Generic Dash", can you add it? Thank you Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 20, 2018 Report Share Posted February 20, 2018 Yes, it can be done. Attach your .cd7 configuration and I will set up the basics. What analog channel did you want to broadcast? Do you just want to broadcast the raw voltage or some calibrated value/unit? Quote Link to comment Share on other sites More sharing options...
o_dd Posted February 21, 2018 Author Report Share Posted February 21, 2018 Do you upload my CD7 configuration file to the forum? Or do you capture the setting screen of CD 7 and upload it? If raw voltage of analog voltage 1 to 11 can be sent, it can convert with CD 7 and display the exhaust temperature In addition, I am glad if I could send the calibrated value to CD 7 Thank you Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 22, 2018 Report Share Posted February 22, 2018 Please attach your .CD7 file and your ECU tune file, I will take a look. Which AN Volt channel do you want to broadcast? Quote Link to comment Share on other sites More sharing options...
o_dd Posted February 22, 2018 Author Report Share Posted February 22, 2018 Analog temperature 4 Fuel temperature Analog voltage 6 M / T temperature Analog voltage 9 Exhaust temperature Voltage display of analog voltage 7, 10 I will attach two files Thank you Subaru WRX V9 G4+ Xtreme Plugin.pclr Default-Black-LinkG4+.aemcd7 Quote Link to comment Share on other sites More sharing options...
o_dd Posted February 28, 2018 Author Report Share Posted February 28, 2018 Was the file I uploaded wrong? Or was it impossible to broadcast an analog voltage? Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 28, 2018 Report Share Posted February 28, 2018 Sorry I just forgot about you after the weekend. I will take a look when I’m at work later. Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 1, 2018 Report Share Posted March 1, 2018 Ok, ecu and dash configs attached below. A couple of comments about your ECU setup: You didnt have any CAN set up so I dont know what CAN port you have wired the dash to. I have assumed CAN 1 and done all set up on CAN 1. AN Volt 6 is set up as a temp input but your cal table 7 is set up for KPa units. You will need to set this to °C for the CAN to work properly. AN Volt 7 is set up as "Alternator %" but the cal table 9 is again set up for Kpa units. You will need to set this to % for the CAN to work properly. Also the error high value on AN Volt 7 needs to be set to non zero to allow it to work. The error high value on AN Volt 10 needs to be set to non zero to allow it to work. o_dd new CAN.aemcd7 O_dd new CAN.pclr Quote Link to comment Share on other sites More sharing options...
o_dd Posted March 1, 2018 Author Report Share Posted March 1, 2018 Dear Adam Thank you for your wonderful work The uploaded file was an old thing by mistake Currently all mistakes are being fixed The set file worked perfectly I am happy and I can not sleep today. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.