Jump to content
sagishm

Problem with v88 on 1.8t ethtottle

Recommended Posts

Hi ,

i got v88 from my friend i install on my car and i get error 70.

i think the configuration not good, i check the manual and the pin layout not same the map ( audi tt base map )

v88  can be replace the me 7.5?

i need another map?

 

thanks

Share this post


Link to post
Share on other sites
14 hours ago, sagishm said:

i think the configuration not good, i check the manual and the pin layout not same the map

If your PInout doesn't closely match the Audi TT, then that ecu will unlikely work.  What pins have you found that dont match?

What car do you have and what is the engine code?

Share this post


Link to post
Share on other sites

Hi

i found the problem with throttle, it’s like i88 in my wiring.

i have another issue, i think the MAP sensor pin nou same, I’m try to MAP calibration and i get error.

elso what about esp/abs, v88 can be work? Because the light is on in the clock.

My car is ibiza 6l bjx engine.

Ecu: ME7.5 ( part number: 06a906032qn )

Share this post


Link to post
Share on other sites
21 hours ago, sagishm said:

i have another issue, i think the MAP sensor pin nou same, I’m try to MAP calibration and i get error.

The MAP sensor is inside the ECU case - it is not connected to any external pin.  It is on ANVolt 1 and MAP sensor type should be set to "2.5Bar".

 

21 hours ago, sagishm said:

elso what about esp/abs, v88 can be work? Because the light is on in the clock.

The ABS lamp probably means the CAN bus messages in your car are a little different than the Audi TT that the ECU was designed for.  You are unlikely able to fix that with a V series as the user configurable CAN is only basic.

Share this post


Link to post
Share on other sites

Yes, since that time in the G4+ range we have added new data into the pre-configured CAN stream to cover a wider range of later model cars including the Ibiza, but you do not have that option with an old V88.  

Share this post


Link to post
Share on other sites
6 hours ago, Adamw said:

The MAP sensor is inside the ECU case - it is not connected to any external pin.  It is on ANVolt 1 and MAP sensor type should be set to "2.5Bar".

 

The ABS lamp probably means the CAN bus messages in your car are a little different than the Audi TT that the ECU was designed for.  You are unlikely able to fix that with a V series as the user configurable CAN is only basic.

i understand, Thanks you!

Share this post


Link to post
Share on other sites
On 4/23/2018 at 1:13 PM, Adamw said:

Yes, since that time in the G4+ range we have added new data into the pre-configured CAN stream to cover a wider range of later model cars including the Ibiza, but you do not have that option with an old V88.  

Hi,

i want to upgrade to G4+, You sure i can to coded for ibiza 6l?

Thanks!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×