Jump to content
Sign in to follow this  
jonnyenglish

MINI Cooper s Wideband sensor wiring

Recommended Posts

Hi Guys,

I have the Link G4+ ecu specifically for the mini cooper s.... I havent yet fitted my ECU but when i do i would like to install a wideband sensor at the same time so that i can get it tuned. Which one would you recommend (was looking at this https://shopbhp.com/products/bosch-lsu-4-9-wideband-sensor-plug-for-link-ecus-long-90cm or this https://www.ebay.co.uk/itm/3844-Innovate-MTX-L-Air-Fuel-Ratio-Wideband-Gauge-Kit-AFR-w-O-Sensor-LSU-4-9-/232726626839, and what additional looms will I require if any? Secondly, how do i got about wiring the the sensor to the ECU i.e. what wire goes where. really would like to get this setup asap if possible!

Thanks for your help,

Jon

Share this post


Link to post
Share on other sites

Hi Jon,

I wouldn't recommend the innovate mtx-l, I had one myself and it just gave up one day. Seems to be a really common overheating fault, I found a lot of online posts about it.

Also the first option is only a sensor, I'm 90% sure you will need a controller as well to connect to the ECU.  I could be wrong here, someone from Link can correct me.

I went with the Link CAN Lambda myself and its been great. It uses CAN so wont take up an input you could use for something else.

Share this post


Link to post
Share on other sites

I use the MTX-L with the MiniLink G4+ on my 2003 R53.

RED wire to switched 12V

BLACK & WHITE wires to GND

YELLOW to Pin 9 (AN Volt 7)

 

Share this post


Link to post
Share on other sites

I would not mess about with analogue inputs anymore, use a CAN based device like the CANLambda that way there is only digital communication from the controller to the ECU and no chance of any discrepancy of calibration.

Share this post


Link to post
Share on other sites
11 hours ago, Alan said:

I use the MTX-L with the MiniLink G4+ on my 2003 R53.

RED wire to switched 12V

BLACK & WHITE wires to GND

YELLOW to Pin 9 (AN Volt 7)

 

And make sure to ground the controller at the same grounding point as the ECU. 

Share this post


Link to post
Share on other sites

Tis annoying because the can lambda is so expensive in comparison. would love it but its double the price. also the fact that it is can how does it get wired in? my other concern is my obd port doesn't work, and im not sure if this is down to dodgy can connections or not....

Share this post


Link to post
Share on other sites

The OBD port is not wired for CAN from factory so you would have to manually wire this up if you want the OBD function. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...