Jump to content
Sign in to follow this  
barge

VVT Table Setup

Recommended Posts

On my v10 Subaru the vvt table has a Y axis of throttle position.

The stock Subaru stuff is all load based and I've done some reading that the VE/Fuel Table Y axis and the VVT Y axis should match. In this case changing to MGP on the Y for VVT. Obviously this would require redoing the table maybe using some reference from stock Subaru or doing some calcs.

Is there a benefit to leaving it?

Benefit to changing it?

Share this post


Link to post
Share on other sites

I have found the tables to be fairly similar when changing between load types, in that it will want max advance around peak torque tailing off either side and at low load you can pull timing out with very little difference to power but some difference in fuel economy.

I would swap to MGP matching the load cells to ones that are present in both the fuel and ignition map and tune from there.

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...