RH9 GTR 0 Report post Posted June 11, 2018 Hello all, I have a 2jz Block with a 1jz Head swap . Will it work with Link G4+ Plugin ECU ? -The 2jz base will work on this setup ? - Which Settings and sensors do i need to check before getting the ECU and letting the car started. Thanks. Quote Share this post Link to post Share on other sites
Adamw 445 Report post Posted June 11, 2018 Can you confirm if both the topend and bottomend are from non-vvti models Quote Share this post Link to post Share on other sites
RH9 GTR 0 Report post Posted June 11, 2018 Hi adam, It has a non vvti 1jz head and 1jz block bored to fit 2Jz pistons. Will the plugin ECU work with it , what will be the trigger settings ? Quote Share this post Link to post Share on other sites
Simon 141 Report post Posted June 11, 2018 That will be fine. The critical bit is to have a match crank and cam trigger form same generation engines So assuming its all non vvt stuff then the base supra map will be a good starting point. Quote Share this post Link to post Share on other sites
RH9 GTR 0 Report post Posted June 12, 2018 Ok Simon Thanks. Quote Share this post Link to post Share on other sites