Jump to content

Recommended Posts

I have link monsoon with 4 bar map internal sensor , i have a problem with its readings , it reads on idle 4.4 psi and when i start to move it increases to 17 psi , btw my boost solonoid adjusted to max 12 psi,

1- I’m connecting a seprated vacum line direct from the intake manifold to the ecu

2-  calibrated on zero rpm

3- connecting on analogue volt 5 

thanks in advance :)

Share this post


Link to post
Share on other sites

Looks ok to me. idle is about 30kpa, and under throttle it jumps up to about 180kpa (ie 80kpa/11.6psi of boost).

It looks like you're struggling to hold boost at this level though as it tapers off over a few seconds, but your MAP and MGP numbers look accurate.

I'd guess that what you are seeing is that the metric>imperial conversion for MAP is working correctly, but its not "normal" to see psi in absolute terms. 30kpa is roughly 4psi, but normally you'd expect to see this as -10.5psi MGP or -22inches of mercury. Remember that 0 psi on a boost gauge (MGP) is 14.7psi absolute pressure (MAP)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×