Jump to content
JcL

rpm limiter with ign cut not bangs not exhaust fire....

Recommended Posts

Hello everyone, I have a Honda h22 turbo with a g4 + extreme and I can not get the rpm limiter to work so that the exhaust spits fire or bangs.

I tried several configurations and in all of them I did the same, a very linear limitation without fire or bangs, both in fuel cut and ign cut and the adaptive or constant cut effect modes and same results.

I have the same problem in both the limiter rpm and the launch control. attached picture of the configuration I use.

 

20180617_220312hjhjhjhj.jpg

I  would like to get something like this.

Also note how in both ign cut and fuel cut modes, at the time of cut my afr meter goes to lean max  (----) as if all the time there was fuel cut and ignoring the ign cut mode.

 

Share this post


Link to post
Share on other sites
7 hours ago, JcL said:

I tried several configurations and in all of them I did the same, a very linear limitation without fire or bangs,

I suspect you will need a very small control range for that type of effect, try 50RPM.  I would also suggest you turn off the hard limit to stop it interfering as you experiment with settings.  

 

7 hours ago, JcL said:

Also note how in both ign cut and fuel cut modes, at the time of cut my afr meter goes to lean max  (----) as if all the time there was fuel cut and ignoring the ign cut mode.

This is normal, a lambda probe measures oxygen content.  If you cut fuel or ignition then there is no combustion so your engine is just pumping oxygen down the exhaust.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...