Jump to content


Recommended Posts

Hello everybody, just bought a WR104 for a 2004 STI 2.5 which had cobb accesport with SD flash, so i am re-using the MAP sensor (which is already working perfectly) and the AEM 30-2010 IAT wired to the MAF connector, I need some help filling up CAL TABLE (not sure if I use CAL1 or 2) and the correct information as I can't find it anywhere, help will be greatly appreciated. 



Share this post

Link to post
Share on other sites

I did Brad but there is no easy table I would have needed to make one from scratch :-D 

Thanks Adam as always spot on! 

12 hours ago, Adamw said:

It looks like it is the same sensor we sell so you can use one of the built-in calibrations.  Set up like below.



Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now