Jump to content
Alan

Can't log SMi™ Gauge Oil Pressure Sensor

Recommended Posts

I've tried AN V8, AN v9, Cal5, and Cal6.  When I put a VOM across AN V8 or AN V9 terminals I see varing voltage in the range of 0.8V  to 1.8 indicating the OP sensor is outpuing "sane" values.

What have I done wrong?

Thanks,

Alan

BMW MINI 031 Large Plenum Intake July 12 2018.pclr

ECU log 2018 July 13 4PM Oil Pressure Test.llg

Share this post


Link to post
Share on other sites

The log suggests there is close to zero volts coming in on ANV9, there is nothing wrong with your config.  How is the oil press sensor ground return connected to ECU?

Share this post


Link to post
Share on other sites

I connected Pin 112 to the GND point used by the Oil Pressure Gauge.  It is an Accutech SMi Oil Pressure Gauge. AccuTech™ SMi™ Oil Pressure Gauge    In other words Pin 112 is connected to the same terminal as the black wire of the Oil Pressure Gauge.  (I did this when using ANV8 - wasn't sure which terminal to GND for ANV9)  Did I miss a GND connection?

 

 

 

Share this post


Link to post
Share on other sites

Found it - Bad connector made by me.  Logging now.  Just need to get the calibration set.

Sorry for taking your time!

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...