Jump to content
Graham

Help Connecting Wideband to G4+ WRX ver 1-2

Recommended Posts

I am installing a Wideband to the G4+ for my WRX ver1-2

I am connecting the wideband output to the Expansion Connector 1 on the LinkECU,  This is connected to the pin labeled Volt 5 (analog 0-5v input).

I can't get any readings to show up on the LinkECU Software

 

I have two questions:

1) Is the the correct input connector to wire the wideband to the LinkECU?

2) what analog input reading do I set to Lambda in the LinkECU software. 

 

Any help would be greatly appreciated

 

Cheers

Graham

Share this post


Link to post
Share on other sites

Yes, AN Volt 5 is fine to use.  Its function should be set to "Lambda 1" and depending on what model wideband you have you may be able to select a calibration from the drop-down list or you may have to use one of the custom cals (cal 4/5/6).  If your wideband device has a separate "analog ground" or "signal ground" then this will also need to be connected to the sensor ground wire on the expansion connector.  If it doesnt have a separate signal ground then it will give best results with the main ground wire connected to the engine block or head.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×