Jump to content
lostsoul

Gear Detection

Recommended Posts

I have gone through the Gear Calibration procedure and got the "Finished" message for each gear. However when the car is out on the road the "gear status" remains at "0".

Can someone check my pclr. file to see if I have missed something?

Thanks

TPS Tune.pclr

Share this post


Link to post
Share on other sites

Seems to look ok to me but with the "normalise ratio table" turned on I dont get to see all the relevant info.  Can you do the cal again with that turned off and give us a log.

I tested your tune on the bench.  With a 3000RPM and 30kmh input signal into the ecu, the software displayed 1st gear.  with 3000RPM, 50kmh = 2nd.  3000RPM, 70Kmh showed 3rd.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×