Jump to content

Gear Detection

Recommended Posts

I have gone through the Gear Calibration procedure and got the "Finished" message for each gear. However when the car is out on the road the "gear status" remains at "0".

Can someone check my pclr. file to see if I have missed something?


TPS Tune.pclr

Share this post

Link to post
Share on other sites

Seems to look ok to me but with the "normalise ratio table" turned on I dont get to see all the relevant info.  Can you do the cal again with that turned off and give us a log.

I tested your tune on the bench.  With a 3000RPM and 30kmh input signal into the ecu, the software displayed 1st gear.  with 3000RPM, 50kmh = 2nd.  3000RPM, 70Kmh showed 3rd.

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...