Jump to content
Sign in to follow this  
Nickr32

V88 RB25 Skyline Idle hold issue

Recommended Posts

I am running a v88 in my R32 RB25 skyline.

Running a non factory plenum with a adapter ca18 idle speed motor. It idles without much issue when cold and warm. 

The issue i have is when the rpm goes above 2100 rpm, when i back off it will hold that for 8 seconds then return to idle. If i free rev it still holds the 2100 area. 
In the idle status section in runtime values it will show IDLE HOLD TIME  whilst at 2100. 

In the link software i can find adjustment portion for it but no where in the VIPEC software. 

Where is it hidden or is there no adjustment??

Share this post


Link to post
Share on other sites

That to me sounds like the Base duty cycle for the idle control is too high. 

Can you do a log of it holding and then returning to a normal idle. 

Include this with the PCL file 

 

Share this post


Link to post
Share on other sites

Simon thank you very much for your help. 
As i was getting the logs of issue, i adjusted the max clamp % from the setting of 95% down to 89% and the idle now holds for a second or so to slow the drop and all is fixed

Thank you again

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×