Jump to content
Toliski

3sgte knock gain

Recommended Posts

Hello guys.

Yesterday I was on dyno and i make some pulls.

I realize that my knock global count was at 1000 (maxed out) from 6000rpm till 8000rpm.

I have Cop setup 

My gain is 1

And my filter is 6hz

Can I put 0 Gain value or -1 etc?

Share this post


Link to post
Share on other sites
1 hour ago, Brad Burnett said:

I would suggest switching to the bosch wideband sensor.  Or you will need to better dial in the knock frequency.

I switch to Bosch then!

Thanks Brad 

Share this post


Link to post
Share on other sites

I would also suggest changing to a common Bosch sensor.  There are quite a few different part numbers but the common one is 0 261 231 006.

 

Also a note about the gain.  On the main knock setup page the "channel gain" setting can only be adjusted in "whole number" increments of 1.  So 1 is the minimum setting that will work here.  However, if you go to the cyl setup page the individual cylinder gains have a resolution of 0.01 so you can use these to adjust the "volume" much more finely.

Share this post


Link to post
Share on other sites
On 9/24/2018 at 4:35 PM, Brad Burnett said:

diagrams are in the help file in the software.

About the ground. Is it better to ground it at ECU ground pin, or at engine block?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...