Jump to content
EvilEvolution8

CAN to OBD2 on Evo 8

Recommended Posts

Hello Guys,

I need to wire the CAN2 of my Thunder to stock harness of Evo 8 (to use the stock OBD2 port).

The Evo 8 pinout says PIN62 and PIN79 are diagnostic ... which one I should user for CAN Lo and CAN Hi?

 

Thanks

Share this post


Link to post
Share on other sites

The Evo 8 didnt have a CAN bus from the factory, Im pretty sure it uses a single wire K-line type protocol, so it will not have suitable wires already in the harness.  Since CAN needs to be twisted pair wires you will be best to run two new wires from the ECU to the OBD2 socket.

Share this post


Link to post
Share on other sites
8 hours ago, Adamw said:

The Evo 8 didnt have a CAN bus from the factory, Im pretty sure it uses a single wire K-line type protocol, so it will not have suitable wires already in the harness.  Since CAN needs to be twisted pair wires you will be best to run two new wires from the ECU to the OBD2 socket.

Ok Adam, thanks a lot ;) 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×