Jump to content
86rotaryman

ABS sensor for wheel speed

Recommended Posts

I'm trying to get an abs sensor on a Eunos Cosmo to send a speed signal to a G4+ xtreme which will then display on an Aim dash via can bus. I'm using DI 1 and have tried all sorts of settings but I'm just not getting any signal. The sensor is a 2 wire, I have grounded 1 wire and the other goes to the DI. I have tried abs sensors on different wheels but still no luck. What am i doing wrong? Thanks.

Share this post


Link to post
Share on other sites

Some 2 wire sensors on ABS are a strange hall effect that need powered

 

Are you sure your 2 wire is a regular inductive sensor ? Have you grounded the wire to signal ground ? Not battery or chassis ground.

 

Can you scope it to see if there is any reaction at all from the sensor ?

Share this post


Link to post
Share on other sites

Thanks for the replies. I also thought the wheel speed could be too slow, so i took the car for a drive but still nothing.

I have tried grounding to chassis and also sensor ground. Im unsure what type the sensor is. I hooked it up to a multimeter and it creates a small mv reading near a metal object.

I might try a different DI channel tonight.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×