Jump to content
Mr2cycle5

R33 GTR Cold start hesitation

Recommended Posts

Hi,

Only had the car a week, but now know it runs terrible when first fired up in a morning from stone cold. It starts on the button, idles fine and has never cut out. The problem starts when I first drive the car. Power totally drops off and I can see from the wideband that it goes far into lean.

I've included the base map and a log

I've compared the post start enrichment and warm up enrichment figures, from my base map to the stock G4+ map and can see a variance in values.

My question is, can I simply change my figures to match? Or do I need to take other factors into consideration (modifiications) and make incremental alterations instead?

Any advice would be much appreciated.

Edit. So the lower the cell number equates to a richer fuel setting...It looks like the lower values I already have set,  suggest it would run richer than the stock base map. Does that point towards a faulty o2 sensor or something else that’s at fault?

K40 SKY Base Map.pclr

K40 SKY cold start.llg

Share this post


Link to post
Share on other sites
9 hours ago, Mr2cycle5 said:

Edit. So the lower the cell number equates to a richer fuel setting..

No, a smaller number means less enrichment (less fuel, leaner).

Post start enrichment is only active for a few seconds after start up so it is unlikely this table is your problem so forget about that for now.  It sounds more like your warmup enrichment table needs work.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×