Jump to content
kool021

skyline R33 series 2 IAT boost solenoid widebend

Recommended Posts

need bit of help can i use XSL loom to wire all these sensors

IAT would i be able to wire it to air flow meter plug if so (ground and sensor input) no positive or connect to positive 

boost solenoid 12v to one wire with fuse and where dos the other wire go?

45731027_2239651359626216_4213004528124952576_n.jpg

Share this post


Link to post
Share on other sites

Is this an old G4 plug-in or a recent G4+?  The pinout for the expansion connectors you show above is for a G4+, but you are posting in the G4 forum.

Need to confirm as that will determine where we can connect the boost valve.

Share this post


Link to post
Share on other sites

You can wire the temp sensor to Expansion 1, one pin to the sensor ground wire, the other pin to temp 3 or temp 4.

For the boost solenoid you can either get a second expansion loom and connect it to either ign 7 or 8, or the other option would be to run a new wire down to the main ECU header and connect it to the pin that is normally used for boost control (pin 25).

For a map just use our GTS base map and adjust the master fuel to allow for the injector size.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...