Jump to content
lostsoul

Hunting Idle on a Cold Start

Recommended Posts

I notice the idle ign control is bouncing on and off but I think that is more a consequence rather than a cause of the problem.  Still you could try increasing the RPM lockout to see if that settles anything.

What I think is more likely the problem is its initially too lean.  Even though your lambda shows 0.85-0.9, the engine seems happier when it sways closer to 0.85, the manifold vacuum increases etc.  Because ethanol has a much lower vapour pressure, you need a much higher volume of fuel to get enough vapour effect when the port walls are cold etc.  As a test try setting one axis of your lambda target overlay table to charge temp and put something like -0.05 in the cells at low charge temps, see if that helps.

 

Share this post


Link to post
Share on other sites

Had a play with things as per your suggestions and a few other thoughts I had. Not looking to bad now ? Using a screen shot of the 1st 30 -40 sec  as the log file was a fraction too big.

 

Cold Start 19th Nov 18.PNG

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...