Jump to content
Sign in to follow this  
archetyp3

Nissan R32 RB20DET - G1, Coil / Tacho info needed

Recommended Posts

Hey there,

 

A friend of mine has decided he wants to go extra period correct and dropped off a Link G1 (With Nissan sub board) for me to wire up. I've worked out everything I need to do aside from being able to use all three ign circuits for wasted spark & using the tacho output function (which seems to only be available on IG3).

Is there a way around this?

Any info would be much appreciated. 

 

I'm also wanting to use the standard Nissan Ignitor, is it possible to fire 2 channels using 1 ignition circuit? ie:

  • ECU IG 1 ----> Ignitor 1/6 ---> Coils 1/6
  • ECU IG 2 ----> Ignitor 5/2 ---> Coils 5/2
  • ECU IG 3 ----> Ignitor 3/4 ---> Coils 3/4

 

Link P/N is 42133BAR & has a mfg date of 07 JUL 00.

 

Cheers
Bevan

Share this post


Link to post
Share on other sites

Assuming that the ECU is on V4 or V5 firmware then when you set the unit up as 6 cylinder and wasted spark it will force Ig3 to be ignition and then the Aux channel will have the option of Shift or Tacho.

Internally the ECU then needs the dip switch configured to suit or on older units there is a resistor and wire link that need to be set correctly.  (we can check this if you take a photo of the ECU with sub-board removed)

 

 

Share this post


Link to post
Share on other sites
On 12/3/2018 at 8:05 AM, Simon said:

Assuming that the ECU is on V4 or V5 firmware then when you set the unit up as 6 cylinder and wasted spark it will force Ig3 to be ignition and then the Aux channel will have the option of Shift or Tacho.

Internally the ECU then needs the dip switch configured to suit or on older units there is a resistor and wire link that need to be set correctly.  (we can check this if you take a photo of the ECU with sub-board removed)

 

 

Have attached a photo of main and sub board for you to take a look at.

He has also bought the cable if any firmware needs updating.

47571454_752838098405633_7451218996667351040_n.jpg

47688082_1018863774953242_1981119919445508096_n.jpg

Share this post


Link to post
Share on other sites

OK she is an old one as it is pre PC tuning so will have to have a hand control to tune it. 

It is fixed for 3 channels of ignition, So tacho will be on the Aux drive if available at all. I can not find any info on the firmware as it looks to be a one off special to give 3 bar map scaling.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×