emresubaru Posted December 21, 2018 Report Share Posted December 21, 2018 Hello, i install pnp v88 my 2004 sti ej207 under boost my car misfires around 5500-6200 rpm i checked runtime values and trigger 1 err counter 5-7 when i change trigger 1 arming thersold and trigger 1 filter car cuts near 7000-7500 rpm and shows no trigger error anybody have an idea? Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 21, 2018 Report Share Posted December 21, 2018 Did you try setting your trig 2 lockout to something like 5000? Quote Link to comment Share on other sites More sharing options...
emresubaru Posted December 21, 2018 Author Report Share Posted December 21, 2018 1 hour ago, Adamw said: Did you try setting your trig 2 lockout to something like 5000? Hello i try to change but nothing change car misfires under load Quote Link to comment Share on other sites More sharing options...
Simon Posted January 7, 2019 Report Share Posted January 7, 2019 Make sure all filters are on level 1 / low and you might need to lower the arming voltages at higher RPMs. emresubaru 1 Quote Link to comment Share on other sites More sharing options...
emresubaru Posted January 8, 2019 Author Report Share Posted January 8, 2019 Hello Simon i will try again and capture trigger scope Thanks Quote Link to comment Share on other sites More sharing options...
emresubaru Posted January 8, 2019 Author Report Share Posted January 8, 2019 i try again trig2 lock out 5000 trig1 and trig2 filters leve1 now car misfires at 7900 rpm trig1 armin 6000 4v 7000v any ideas please Thanks Quote Link to comment Share on other sites More sharing options...
neil brown Posted January 8, 2019 Report Share Posted January 8, 2019 What’s the Rev limit set to ? could you be hitting max revs ? Whats the engine good for ? Quote Link to comment Share on other sites More sharing options...
emresubaru Posted January 8, 2019 Author Report Share Posted January 8, 2019 20 minutes ago, neil brown said: What’s the Rev limit set to ? could you be hitting max revs ? Whats the engine good for ? Hello Rev limitler set to 8000 rpm sometimes cut 8000 sometimes cut 7800 rpm Quote Link to comment Share on other sites More sharing options...
neil brown Posted January 8, 2019 Report Share Posted January 8, 2019 You could have a soft cut Rev limiter you need to check the Rev limit section Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 9, 2019 Report Share Posted January 9, 2019 The default limiter setup uses a control range of 200rpm, this means if the limiter is set to 8000, the ecu will start applying a limit at 7800. Quote Link to comment Share on other sites More sharing options...
emresubaru Posted January 9, 2019 Author Report Share Posted January 9, 2019 Hello, i check my rev limit section advanced mode is off i will try again Thanks Quote Link to comment Share on other sites More sharing options...
emresubaru Posted January 12, 2019 Author Report Share Posted January 12, 2019 Hello Problem solved thanks too much for suport trig lockout 5000 trig1&triger2 filter 1 no misfires Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.