Jump to content
golf-2

m50 crank signal

Recommended Posts

Both crank and cam are incorrect polarity in that capture.  Also with the cam tooth being right in the middle of the crank gap could potentially be a problem.  Set the trig 2 like below usually works best in this case (set as hall instead of reluctor):

2vru13c.png

Share this post


Link to post
Share on other sites

Correct, with a missing tooth crank wheel the cam is only used for phase detection.  So really the most important aspect is the cam edge that you are using must always occur on the same side of the crank gap.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×