Jump to content
Alexbrig

VQ30 36-2 trigger injector/ignition wiring and setup

Recommended Posts

Hello,

 

Please advise correct injector and ignition wiring and setup for VQ30DET engine with 36-2 crank trigger wheel using hall sensor from VQ35 on G4+ Fury. If configured as 3 cylinder 2 stroke engine and wired by grouping 1-4, 2-5, 3-6 cylinders 's injectors and coils respectively will it work correctly? Can't use cam sync at this point for full sequential operation. Firing order on VQ's is 1-2-3-4-5-6

Did read about group fire mode, but not sure if it will work correctly on this setup.

 

Share this post


Link to post
Share on other sites

It should be configured as normal, 6cyl, 4 stroke.  

Set injection mode to multi-point group and injection rate to 1/2 cycle.  Set ignition mode to wasted spark.  Set trigger 2 sync mode to none.

Coil pairing is correct but personally I would have wired the injectors individually cyl1-inj1, 2-2, 3-3 etc, as it would have given more even pressure pulsations in the fuel rail but it will still work as you have done.

Share this post


Link to post
Share on other sites

Correct, so with my suggested wiring you would have 3 injectors squirting at the same time, then 360deg later the other 3 squirt.  With your present wiring you will have 4 injectors squirt together, then 360deg later 2 injectors squirt.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...