Jump to content
Doga

G4+ Evo Plug in Bosch DBW Setup

Recommended Posts

Hello, I have upgraded my G4 link to G4+ E-throttle. I am aiming to use Bosch 82mm Throttle (0 280 750 473) Anyone have the PID setting for this Throttle? Also any suggestions about the pedal to use?  

However the plug in ecu doesnt have +14v Aux9/10 input. Can I run this ecu without an external E-throttle relay? 

 

 

Link dbw.JPG

Share this post


Link to post
Share on other sites

While I don't have PID settings handy, they shouldn't be too difficult to work out.

I typically like to use the Subaru STi pedal.  The early 04-05 units can be had off ebay for usually around $40 shipped.

You will need the external ethrottle relay for safety operations.

Share this post


Link to post
Share on other sites

Brad thank you, its a very common throttle body so should be easy to find,

Then which pin is the highlighted (+14v Aux9/10) on G4+ Evo8+ Plug in ecu ? 

Share this post


Link to post
Share on other sites

You donot need an external e-throttle relay for the plug-in ECUs.  However you still need to assign a spare aux or virtual aux as e-throttle relay in the software for it to work.  I have found the PID for the BA Falcon are usually very close for the common Bosch throttles.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×