Jeffersonc Posted February 1, 2019 Report Share Posted February 1, 2019 Can I connect an AEM wideband to a plug&play G4+without using the expansion loom? I see AN Volt 4 & 5 are AFM signals (front/rear). Will one of these work? Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted February 1, 2019 Report Share Posted February 1, 2019 Yes, either will work, just select lambda1 for the corresponding input in the link software. You might need to connect the sensor ground too. HTH, Richard. Quote Link to comment Share on other sites More sharing options...
Jeffersonc Posted February 1, 2019 Author Report Share Posted February 1, 2019 Thank you. That was my next question, what ground would be sufficient? I see Pin 50 is "Ground" or signal ground is expansion 1. Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted February 2, 2019 Report Share Posted February 2, 2019 Yes, pin 50 should be fine. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.