Jump to content
Zensation

injector staging isssue

Recommended Posts

I have a quick question regarding my link fury injector staging on my rx7.  I have secondary injectors set to stage in at 6.5 psi (MGP) to take on 10% of the overall flow in the staging table at 8psi its set to be 25% and so on until the pulse widths match at 12.3psi.   im looking at a log and i can find that at shortly after the 10 minute mark my injector staging table value reads 34% but my secondary inj duty cycle value is always 0 while my primary injectors are over 100% duty cycle.  i have a 3000 rpm secondary lockout as well as a 3 ms lockout set but neither of these should affect the secondaries as the rpm is close to 4000 and im sure at providing 34% of flow the ms value should be greater than 3. am I missing something?  I have attached my tune but the log is 5mb and wont let me upload so i attached a screen shot that shws 'inj duty cycle (sec) to be 0 at the moment when the staging table reads 34%.  thanks is advance for your help.

0 sec pulse width log.png

g-finale_rev3.pclr

Share this post


Link to post
Share on other sites

It is the minimum pulsewidth lockout.  In the screenshot above you have a primary pulse width of 16.011ms.  34% of this would be 5.44ms.  Your sec/pri ratio is 2.38, so the calculated secondary pulse width to achieve 34% of that total fuel flow would be 5.44/2.38 = 2.29ms. 

I suggest dropping that PW lockout down to 1.5-1.8ms since you have small primaries.

Share this post


Link to post
Share on other sites

thanks adam.  I realized this after posting. i think i may need to have them kick on to a larger contribution earlier in the staging table as well as the 2000cc injectors are fairly non linear below 2ms pulse widths. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...