Bananawasp Posted February 25, 2019 Report Share Posted February 25, 2019 Hi all I have just purchased a can lambda kit to go with my link ECU. I have follow the instruction to wire it but I'm struggle to find the can device in my ECU. I have wired the can high to pin 3 and I believe can low to pin 4 on the ECU side. Does that sound right? Is there something I'm doing wrong? Thanks Quote Link to comment Share on other sites More sharing options...
Tim D Posted February 25, 2019 Report Share Posted February 25, 2019 That sounds right, I looked up this from the help file: For info, here's what my CAN settings show for CAN Lambda: Not sure if that help? Quote Link to comment Share on other sites More sharing options...
Bananawasp Posted February 25, 2019 Author Report Share Posted February 25, 2019 Hi I'll try it again. On the G4+ mini link it automatically adds some of the settings I might try and use the user defined instead. I wasn't sure at first if I was using the pins on the side of the connector. Ie when you mate the connectors together pin 4 on the ECU is pin2 on the canf connector if you get my meaning. Thanks for the response. Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 26, 2019 Report Share Posted February 26, 2019 6 hours ago, Bananawasp said: Hi I'll try it again. On the G4+ mini link it automatically adds some of the settings I might try and use the user defined instead. I wasn't sure at first if I was using the pins on the side of the connector. Ie when you mate the connectors together pin 4 on the ECU is pin2 on the canf connector if you get my meaning. Thanks for the response. Attach your tune file, it sounds like you are doing something wrong. It shouldnt add any settings on its own. There is a Pinout for the CANF in the help file. This is looking from the side you solder the wires into: Quote Link to comment Share on other sites More sharing options...
Bananawasp Posted February 26, 2019 Author Report Share Posted February 26, 2019 So after changing my settings i got the lambda sensor working. In the mode drop down box I selected the setting for mini r53 and was hoping it would just pick up the setting. Thanks for everyone that helped! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.