Jump to content
Woody

CAN RPM output

Recommended Posts

Hi all , i need to get a proper rpm signal to my Dyno software , it supports OBD and works spot on with this , the inductive and capacitive clamps are not that brilliant and very spikey.

My thinking is to use the CAN output from G4+ to send rpm signal to my OBD input .

Any ideas , thanks in advance .

 

Cheers Keith

Share this post


Link to post
Share on other sites

Hi Keith, you can get Engine Speed on PID0C and vehicle speed on PID0D for setting the run up via OBD, select the CAN port select user defined, select the highest speed your dyno will read OBD in, usually 500kbs, and then check the ISO 15764-4  checkbox on the right.

Share this post


Link to post
Share on other sites
On 3/7/2019 at 11:12 PM, ClintBHP said:

Hi Keith, you can get Engine Speed on PID0C and vehicle speed on PID0D for setting the run up via OBD, select the CAN port select user defined, select the highest speed your dyno will read OBD in, usually 500kbs, and then check the ISO 15764-4  checkbox on the right.

Thanks Clint , will give it a go..

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...