CAN Transmit Channel: Link G4+ Evo PnP + Motec C127

[netprosto]

Hello!

How I need to configure Link G4+ Evo PnP and Motec C127. I want to transmit AN6 signal from Link G4+ to C127.

I made it. It's not working. What was my mistake?

Thanks in advance for your reply!

Link G4+ Config

 

Motec C127 Config

 

[Adamw]

1. Motec use hexidecimal notation for the CAN ID/Address, Link use decimal.  Hex 384 (motec end) is decimal 900 (set at link end).
2. Motec use the terminology "Alignment: word swap" to refer to LS byte first, so change that to normal.
3. Uncheck the "signed" checkbox in the motec setup as you are sending from the Link unsigned data.
4. Put a multiplier of 10 at either the Link end or Motec end.  This is because Motec uses 0.1°C resolution for EGT, Link uses 1.0°C.

[netprosto]

On 3/18/2019 at 12:59 AM, Adamw said:

1. Motec use hexidecimal notation for the CAN ID/Address, Link use decimal.  Hex 384 (motec end) is decimal 900 (set at link end).
2. Motec use the terminology "Alignment: word swap" to refer to LS byte first, so change that to normal.
3. Uncheck the "signed" checkbox in the motec setup as you are sending from the Link unsigned data.
4. Put a multiplier of 10 at either the Link end or Motec end.  This is because Motec uses 0.1°C resolution for EGT, Link uses 1.0°C.

Thank you so much!

You can get me the config file of Motec C127 for Link Generic Dash or Generic Dash 2?

[Adamw]

9 hours ago, netprosto said:

You can get me the config file of Motec C127 for Link Generic Dash or Generic Dash 2?

I have one already set up for Generic dash, I dont have one for Generic dash2.  

Motec Can channels (2).xlsx Link G4+ Generic Dash to Motec C127.CC8

[netprosto]

15 hours ago, Adamw said:

I have one already set up for Generic dash, I dont have one for Generic dash2.  

Motec Can channels (2).xlsx 18.63 kB · 0 downloads Link G4+ Generic Dash to Motec C127.CC8 8.34 kB · 0 downloads

Thank you!