Adzn3k Posted March 31, 2019 Report Share Posted March 31, 2019 Hi guys, I'm fitting a Bosch 2 pin knock sensor in place of the oem single pin one. On have all the correct shielded wire but looking for info on wringing up, am I correct in thinking I only use 1 of the pins for the signal wire and the other is grounded like the shield? Any info greatly appreciatedĀ Quote Link to comment Share on other sites More sharing options...
BigBoiMR2 Posted March 31, 2019 Report Share Posted March 31, 2019 pin 42 for knock sensor input pin 46 for ground wire and shield ground. only ground one end of the shielding and make sure its connected to the pin or it may pick up more interference. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.